Helmholz 700-640-CAN11 CAN 400-1, with 1 CAN interface

The CAN 400 module, for use in an S7-400* from Siemens, enables connection of CAN participants with the automation device.
The module can be plugged into either the central frame or the expansion frame.
It supports CAN 2.0A (11 bit) and CAN 2.0B (29 bit) frames with a freely selectable transfer rate from 10 kbps to 1 Mbps.
The module contains the scripts for “Power On”, “Stop -> Run”, “Run -> Stop”, “Power Off”. Using a multi-stage acceptance mask, relevant IDs can be pre-filtered for the automation device.

The CAN 400-1 can be operated as Layer 2, CANopen® master or CANopen® slave.
With the module, 16 freely settable timers up to a resolution of 1 ms are available. Each timer can trigger a freely programmable CAN telegram. This means the synchronous protocols widely available in drive and servo control are also easy to implement using the CAN 400-1.

• Layer 2, 11 bit and 29 bit (CAN 2.0A/B)
• DIP switches for address + transfer rate
• USB interface for parameterization and diagnostics
• Extensive CAN bus diagnostics possibilities
• Can also be used as CANopen master or CANopen slave
• 1 CAN interface

• General information
  	Order number	700-640-CAN11
  	Article name	CAN 400-1, with 1 CAN interface
  	Scope of delivery	CAN 400-1
  	Dimensions (DxWxH)	290 x 210 x 25 mm
  	Weight	Approx. 900 g
  CAN interface
  	Number	1
  	Type	ISO/DIN 11898-2 CAN High-speed physical layer
  	Transmission rate	10 kbps ... 1 Mbps
  	Protocol	* CAN 2.0A (11 bit)/CAN 2.0B (29 bit) Layer 2 CANopen® Master/CANopen® slave * SAE J1939
  	Connection	Connector, SUB-D, 9-pin
  Status indicator		6 LEDs
  Configuration interface
  	Type	USB 1.1
  	Connection	USB B socket
  Voltage supply
  	Voltage supply	+5 V DC via backplane bus
  	Current draw	560 mA
  Current draw		560 mA
  Ambient conditions
  	Ambient temperature	0 °C … +60°C
  	Transport and storage temperature	-25 °C … +75 °C
  	Pollution degree	2
  	Protection rating	IP20
  	Certifications	CE